Register Calendar Latest Topics
 
 
 


Reply
  Author   Comment  
DNA RACING

Avatar / Picture

National Contender
Registered:
Posts: 973
Reply with quote  #1 
i have been having issues with 1 of my bearings popping out of the wheel non stop. i just could not get it to stay in no matter what trick i used. i ended up using a tooth pick and some blue RTV silicone to fix it. just use the tooth pick to apply a VERY small dab on the inner lip of the bearing in a couple of areas and insert bearing. let sit for a few minutes and good to go. it will still be removable if needed later. just make sure to stay away from the inner edge.
just figured i would pass that along in case anyone else had that problem.


__________________

X-TEAM RED CAPTAIN



FREAKY LIVES





http://scouternationals.weebly.com/
0
quadad

Avatar / Picture

National Contender
Registered:
Posts: 579
Reply with quote  #2 

Most of the time they are quite tight.  I haven't had any pop out.  Try turning that energy into increased momentum in the forward direction !!!


__________________
0
Kinser Racing

Avatar / Picture

Out to pasture
Registered:
Posts: 4,511
Reply with quote  #3 

Nice job. If it happens again just switch bearings around until one fits better.


__________________
0
Skippy Kicky

Avatar / Picture

Pinevalent Soul
Registered:
Posts: 459
Reply with quote  #4 
I am relatively new to this forum. I have enjoyed reading all of your posts. I am extremely grateful for all of the good information. You all have been extremely helpful. Does anyone have good advise how to safely remove bearings? I have some goat wheels on order that I would like to transfer some bearings from bsa wheels into.
__________________
0
Kinser Racing

Avatar / Picture

Out to pasture
Registered:
Posts: 4,511
Reply with quote  #5 

Quote:
Originally Posted by Skippy Kicky
I am relatively new to this forum. I have enjoyed reading all of your posts. I am extremely grateful for all of the good information. You all have been extremely helpful. Does anyone have good advise how to safely remove bearings? I have some goat wheels on order that I would like to transfer some bearings from bsa wheels into.

 

I use an Exacto knife and slowly work it around the bearing flange where it meets the wheel. Then I use my finger nails and pull gently until its out. Do it over a sheet or something in case it tries to get away from you.


__________________
0
Quicktimederby

Avatar / Picture

Top 50 Ranked!
Registered:
Posts: 2,378
Reply with quote  #6 
+1
Quote:
Originally Posted by Kinser Racing

I use an Exacto knife and slowly work it around the bearing flange where it meets the wheel. Then I use my finger nails and pull gently until its out. Do it over a sheet or something in case it tries to get away from you.

__________________
0
Previous Topic | Next Topic
Print
Reply

Quick Navigation:

Free Hit Counter
PinewoodDerbyOnline